The design made of two even slopes directed down and having the same angle of inclination – a gable roof. From the abundance of winter precipitation, you can calculate the necessary angle of inclination. For work you need:
– Nails No. 200.
– Log or timber.
– Plumb.
– Tes.
– The level is laser.
After the walls are erected, when working with a ceiling overlap, it is necessary to release beams, a little further than the level of the end of the wall. These released beams should be nailed using tes nails. When the overlap is built, you need to start installing the rafters. They can be made of a skinny dry log or a bar. The first rafters should be installed in the middle, and their upper part should be sawn down along the corner of the inclination of the entire roof. Recently, roofing work has been often carried out more about them will not be superfluous to find out.
The base intended for slopes will be attached to the rafters. The whole structure is fixed with nails. If suddenly the nails make their way through, then their edges that have performed can be bent with a hammer. In the case when the rafters are installed in the middle of the ceiling, the pitched rafters must be made exactly. Therefore, everything needs to be checked with a laser level.
The rafter structure is fixed using slopes fixed by the bar. So that there are no gaps, it is necessary to sheathed the pediments with tes on both sides. A crate from the tes is installed on top of the slopes, which is covered with roofing material.