When fundamentally new materials or technologies appear on the market, a qualitative leap occurs, which allows to significantly accelerate the initiative processes, and get the final result with an increase in the economic effect, from the introduction of innovations.
The use of the material of Waterplag allows you to avoid a fairly large amount of problems in a short time. If we review what happened in the field of eliminating pressure leaks before the appearance of this material, it will be possible to see and evaluate how simplified the life of the builders and operating rooms of various concrete structures.
When the leak appears, according to the technology of the use of Waterplag, the following operations must be performed.
Using a perforator, divide the hole of the leak into 6 centimeters in diameter and to the same depth. The shape of the cut should resemble a swallow tail. That is, the tape of the punch should be kept at a slight angle to the surface perpendicular, so that the diameter is more than outside inside. This shape of the hole will contribute to the better fixing of the waterplag in the body of the wall.
Next, you need to clean the hole of the hole and the area around it from fat oil pollution, old paint, crumbling plaster and other inclusions that will prevent the clutch of the water plug and concrete surface of the wall.
Method of preparing a solution of waterplag:
After completing the necessary preparation of the surface, you can proceed to the preparation of the solution of the waterplag itself. However, this must be done quickly and prepare such a volume of solution so that it can be developed in 2-3 minutes-the time of setting the solution. Place the prepared mixture in the hole, and by covering it only half the depth. Then treat with penetron, and fill the remaining space with stumpritis. Then re -treat with penetron. Such measures can prevent moisture penetration through micropores. An overly protruding solution must be removed immediately, because then it will be difficult to do. When embarrassing large vertical cracks, you need to start the seal from top to bottom
Temperature mode:
The optimum temperature of the flowing water is 20 ° C, when the temperature decreases, the grasp will occur slower. Depending on the temperature of the water and the flow rate of the water, the more or less thick consistency of the mixture is made.
In the future, the properties of the embedded pressure and properties of the wall will be identical, including the coefficient of thermal expansion. Therefore, you can carry out any finishing work, not paying attention to the difference in the material.
The simplicity of the technology of using Waterplaga makes it affordable material for use in various fields.
Official representation of the waterproofing system in Moscow – Omega Group of Companies.