Modern locks with code can be subject to transcoding, which can be very useful. To do this, you will need new keys corresponding to this type of closing device.
Perekoding of a mechanical lock
At the first stage of recoding, you should carefully read the instructions and all documents available on the castle. Change the code carefully and meticulously.
For the transcoding process, you can choose the outer and or inner door line. The door first needs to be opened, and then put a special individual key in the lock of the castle, which goes in a set with the lock itself. The key is rotated until the latch appears. Further into the cavity located under the well, a certain device is inserted, which must be pressed on the insides of the well until it stops. Then again a special key is used. He turns against the movement of the watch arrow until the characteristic click appears, which is a kind of command to pull out the key. See more detailed instructions on the site 2.PHP.
Now a new key is taken from the kit and is invested in the well of the castle device, and then it is turning to the end. Can be twisted in the opposite direction to make sure of the debugged and uninterrupted operation of the castle.
What to do with a code castle?
The code lock can also be transcoded. Such locking mechanisms are rapidly gaining momentum of popularity. Experts advise reducing them once every three months.
To install a new code, it is necessary to remove the locking mechanism. Only the hull cover is removed from the door. The entire mechanical device should not be removed. Next, all the bolts available on the device are displayed. They reliably fasten the safety cover located in the inside of the closing device. Such manipulation will help to get special encoding plates. Each such plate has a unique device. This is usually a miniature cut that has a different focus. The plates that contribute to the creation of a code combination, as a rule, have sections facing the castle mechanism. If the plates do not participate in the formation of the combination, then their plates “look” outward.
When the plates are removed and set out with cuts, the issue with a new combination should be resolved. Then you need to select the plate corresponding to this combination and move so that their sections are turned into the device. At the finish stage, safety plates, as well as the body of the mechanism are installed in the same place.